UserGate Mail Server

  Administrator's Manual

Menu
  • UserGate Mail Server Quick Setup

UserGate Mail Server Quick Setup

 
All UserGate Mail Server modules will run automatically upon installation. To quickly configure the server, complete the following minimum setup:
 
 
NOTE! The default assumption is that your DNS server has the corresponding MX record for your mail domain. The MX record should be pointed to the external IP address of the computer where your UserGate Mail Server is installed. UseGate Mail Server should be accessible over SMTP (TCP port 25) protocol from the Internet.
 
To enable the spam filtering modules to perform properly, the network settings of the computer on which your UserGate Mail Server is installed must have correct address of the DNS server configured for domain resolution. By default, UserGate Mail Server will use the DNS server specified in the computer’s network settings. However, you can list one or more additional DNS server addresses on the “UserGate Mail Server –Settings” page of the administrator console.